Engraving, Marking & Chamfering
| Tool | How It Works | Choose It When |
|---|---|---|
| Puma AT-6062 Air Engraver Pen | Air-driven needle, 13,000 blows per minute; thick needle supplied, fine and medium available | You mark tools and components by hand at low cost. |
| ENESKAmarker 300 | Laser marking with no force or contact, in a sealable, screened working area | You need durable, repeatable marks on thin-walled, ground or finished components. |
| Nitto Circuit Beveler CB-01 | Air-driven chamfering tool for radius chamfers on holes from 6.8mm and on straight and curved edges | You break edges and chamfer holes on stainless and mild steel. |
Engraving or Laser Marking?
An engraver pen marks by impact, so it suits robust parts and quick identification. A laser marker applies no force, so it suits thin-walled, ground and finished parts where an impact mark could distort or damage the surface.
Both air tools need a compressed air supply; see Air Tools for filter, regulator and lubricator kits.
Need Help Choosing a Marking or Chamfering Tool?
Contact Moleroda with the material, the size of the parts and the marks or edges you need.
Frequently Asked Questions (FAQs)
An engraver pen is a low-cost hand tool for marking robust parts. A laser marker gives durable, repeatable marks without contact and suits thin-walled or finished components.
The Puma AT-6062 is supplied with a thick needle; fine and medium needles are also available.
The Nitto CB-01 produces radius chamfers on holes from 6.8mm diameter and works on straight and curved edges.
The ENESKAmarker 300 has a sealable, screened working area for safe operation. Contact Moleroda to discuss installation and your parts.



